SGABCM | Bridge Completion Module for SGA

SGABCM Bridge Completion Module
Price: $62.00
  • Easy installation – simply screws into the existing load cell connector on the SGA
  • On-board screw terminal connections accept a wide range of bridge completion resistor enabling on-site installation without soldering equipment
  • High stability resistors (5ppm/°C) fitted for the ‘fixed’ arms of the bridge
  • A half bridge strain gauge is simply connected to the BCM module via the screw terminals, no additional components are required
  • The quarter bridge strain gauge circuit, together with its completion resistor can be wired for compression or tension giving a positive output
  • Small footprint: approximately 53x32mm, screws into existing J2 connector

 The SGABCM is a retro-fit PCB which facilitates connecting a half or quarter-bridge strain gauge to the SGA Load Cell Conditioner. This unit can also be bought in conjunction with an SGA.

 The PCB comes with a 5ppm/°C resistor for 350 Ohm bridge completion (both quarter and half) and a shunt cal resistor.

The SGABCM is compatible with all variants of the SGA i.e. SGA/A, SGA/D and SGAs fitted with the IS1224 isolated DC power supply module.

SGABCM Dimensions
Q: What is the SGABCM module?

A: The SGABCM is a retro-fit PCB which facilitates connecting a half or quarter-bridge strain gauge to the SGA load cell conditioner.  

Q: Will the SGABCM work with both A (AC) & D (DC) versions?

A: Yes

Loading...